Logo

C3124 Engine Trouble Code

Meaning of C3124 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C3124 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for C3124 code is occuring now you should check C3124 repair processes.
Now don't ask yourself; What should you do with C3124 code ?
The solution is here :

C3124 Possible Solution:

C3124 Engine

Disconnected, dirty or fouled spark plugs are common causes for engines that won't start. Spark plugs typically need to be replaced every season or 25 hours of use. You should also check that the spark plug gap is set properly. If your spark plugs look good, problems with your ignition system can also preventing a spark. These can range from a faulty spark plug lead, shorted kill switch or flywheel key damage.

C3124 Code Meaning :

C 3 1 2 4
OBD-II Diagnostic Chassis (C) Trouble Code For Engine Ignition System Or Misfire Fuel Rail/System Pressure - Too High Turbocharger Boost Sensor A Circuit Low Timing Reference High Resolution Signal A Too Many Pulses

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

C3124 OBD-II Diagnostic Chassis (C) Trouble Code Description

C3124 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For C3124 Code

The reason of C3124 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

C3124 DTCs may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.